Fiamma awning not closing properley.
Fiamma awning not closing.
1 remove both end caps with a screw driver.
Please see the fiamma f45 trouble shooting guide for information on repairing the lead bar sorting the arms regulation and changing the canopy.
If the material has stretched at one end which does happen the correct fiamma approved method to cure it is to wind the awning right out at the end which is the slack end you place a small piece of gaffer tape on the roller so the material rolls over it.
Make sure your awning is completely dry and clean before closing it as the remaining humidity could stain the fabric.
Believe me this is the correct only method to take up slack in one end.
Just opened the awning on our new van today initially the awning wouldn t open and needed a little help from each end when closing the awning the front cover was about 1 inch below the housing and i had to get on a ladder and lift the unit to enable it to be fully closed.
4 loosen boltz on leg supports using a 13mm wrench and slide legs out of rail.
3 remove the case cover.
Our fiamma f45i awning was not closing at the end opposite the winding mechanism.
2 unroll the awning open about 30cm and remove the front screws on right side inner end cap.
Fiamma awning adjustment to make it close all the way.
Remove screws on left side also.
Reading the rather sparse instructions in the fiamma handbook i tried adjusting the presto fix which should realign the roller laterally but it seemed to make no difference.
When i crank it in the front latches nice and snug but the rear always just kind of hangs out.
All awnings are properly adjusted before they leave fiamma but over time the canopy could become loose on the sides and the awning may not close properly.
An rver asks gary bunzer the rv doctor why the awning on his recreational vehicle will not retract evenly and what he can do to f.
So the rear of my awning does this.